Loading ...
Loading ...
Loading ...
GEAppliances.com
Service: Manually Initiated Electronics Diagnostics
I. To enter diagnostics, press and hold ._%_
tile MODEbutton for 3 seconds until
tile LOWSALTALARMscreell shows. _/)) 0 I-!
ZPresstheMODEbutton2tin_esto _ n O]
advance throu,,h LOWSALTALARM 0
and SALTEFFICIENCYoptions. See n n ["1
Programming the Control for details IJ Ij U
011 these two optiolis.
3. OPERATIONOFDIAGNOSTICS
Motor Position
Valve | .. switch
P°S't'°n "_1_. _.t!
Water meter
"Valve Position--Press tile RECHARGE @ button to
initiate a recharge cycle. Press again to manuallx index
xalxe to next position. See Service." Manually Advance
Recharge Checkfor details.
0 - Serxice
1 - I?ill
2 - Brine
3 - Backwash
4 - Fast Rinse
" Motor Operation--Two dashes will circulate armmd
when motor should be umning
• Position Switch Operation--
I-
L - Closed--\alxe rotating to next position
ul
u - Open--\alxe in position, serxice, fill, brine, etc.
• Water Meter--Indicates whether water is flowing
throuoh xalxe.
Position-_,-
switch
.Sensor
housing
Valve
outlet
pport
andshaft
- 000 indicates no water is flowing through tile valve
- Open nearbv soft water taucet
- 000 to 199 (continual) shows water is flowing. Display
repeats tor each galhm of water passing through tile
meter. Control will beep at every gallon.
- If there is no reading in tile display, with fimcet
open, check the sensor. Pull the sensor fl'om the
valve outlet port, and pass a small magnet in fl'ont
of tile sensor. Counter should index in tile display.
If counter does not index, check to make sure
harness is cmmected to board properly. If there is
a reading in tile displa)', there may be a problem
associated with tile turbine. Turn off water supply,
close the by-pass wflve, and disconnect by-pass wflve
fl'om valve body: Check tm'bine fl)r binding or
restriction due to debris. If this does not correct
the problem, tile Timer, Sensor or Tufl)ine may
require replacement.
4. Historical data about tile softener is available.
* Press and hold tile UP • button to display tile nmnber
of days this control has had electrical power applied.
e Press and hold tile DOWN • button to display the
number of recharges initiated by this control since tile
model code nulnber was entered.
5. Press tile MODE button to return to normal operation
and (lispla}.
Service: Set Model (For H) Code
I. To chan,,e_ or check model code, first press and hold tile
MODE button for 3 seconds until tile LOW SALTALARM
screeil shows.
Z Press and hold tile MODE button again
fi)r 3 seconds. A display with E OC[ at
the top will appear.
3. Press tile UP • or DOWN • buttons
to select the correct model code.
F 18-GXSF 18(,
4. Press tile MODE button ()tie time to return to nomml
operation and display. If tile model code was changed:
• tile display will go blank momentarily, then display tile
model code entered.
* tile display will then return to tile set present time
display, and tile blue indicator light will flash. Tile
control will have to be reprogrammed. See Programming
the Control
NOTE:If tile control is left in any of tile above diagnostic
displms or a flashing displa)when setting time, hardness,
etc., it will rexert back to tile normal display in 4 minutes.
17
Loading ...
Loading ...
Loading ...