Richmond RMTGHRH111DVLN Encore 11 GPM 199,900 BTU Tankless Natural Gas Water Heater

User Manual - Page 26

For RMTGHRH111DVLN.

PDF File Manual, 86 pages, Read Online | Download pdf file

RMTGHRH111DVLN photo
Loading ...
Loading ...
Loading ...
AP18733 REV. 3.2.17
26
WARNING
WARNING
The water heater must be installed on a wall that can bear its weight (more than 88 lbs. [40 kg] when fully plumbed and full of water). Installing the
water heater on a wall which cannot support its weight could result in property damage, personal injury, or death.
This water heater is too heavy for one person to lift. It is highly recommended to install the water heater with two people. Use caution as to not
drop the water heater, which could damage the water heater and cause property damage and/or severe personal injury. Verify that the water
heater is properly and securely mounted before leaving unsupervised. Failure to comply with the above and properly mount the water heater could
result in substantial property damage, severe personal injury, or death.
This wall mounting system is not seismic rated and should not be applied as such. Failure to comply with the above and properly mount the water
heater could result in substantial property damage, severe personal injury, or death.
J. WALL-MOUNTING THE WATER HEATER
IMPORTANT
Cold weather handling If water heater has been stored in a very cold location (below 0°F) before installation, handle with care until the plastic
components come to room temperature.
Remove all sides of the shipping crate to allow the water heater to be lifted into its installation location.
The water heater may be installed on any suitable internal wall (suitable sound-proong may be required when installing onto a stud partition wall).
POSITIONING THE WATER HEATER ON THE WALL
1. Attach the wall bracket on the location where you want to install the water heater. Ensure it is level and on stud (16" [406 mm] centers)
before proceeding.
2. Mark the two (2) drill holes with a pencil or marker. Remove the wall bracket.
3. Drill two (2) holes using a 15/32" (12mm) drill bit at the marked hole locations.
4. Mount the wall bracket to the wall with the two (2) included anchor bolts. Ensure the mounted bracket is level. Place washers and nuts on
each anchor bolt and tighten. See Figure 4.
5. Align the heater bracket grooves on the back of the water heater with the tongues on the wall bracket and hang the water heater on the
bracket. See Figure 4.
6. Locate the lower mounting
bracket on the bottom of the water
heater. The two (2) screws and dry
wall anchors will be used to secure
the bottom of the unit to the wall.
7. Mark two (2) holes. Remove the
water heater from the wall.
8. Drill two (2) holes with a 17/64"
(7mm) size bit. Then insert two (2)
dry wall anchors into the wall.
9. Place the water heater back on
the wall as described in Step 5.
10. Screw the two (2) screws into the
dry wall anchors.
Figure 5 – Wall Mounting the Water Heater
Figure 4 – Wall Mounting the Water Heater Top BracketHeater
Position the bracket securely to the wall.
Afx the screws into dry wall anchors.
Loading ...
Loading ...
Loading ...