Loading ...
Loading ...
Loading ...
USER MAINTENANCE INSTRUCTIONS
36
www.insigniaproducts.com
No water or not
enough water
OR
Detergent or
softener is still in
its compartment
after the wash
cycle is
completed
• Make sure that both faucets are fully turned on.
• Make sure that the water pressure is in the range listed in Water
requirements on page 19.
• Make sure that the water inlet hoses aren’t kinked. Straighten if
necessary.
• Disconnect the hoses and clean the hose filter screens. The
screens may be clogged.
Washer vibrates
or is too noisy
• Make sure that your washer is set on a level surface. If the
surface isn’t level, adjust your washer’s feet to level your
washer. See Step 4: Level your washer
on page 27.
• Make sure that your washer isn’t touching any other object.
• Make sure that the laundry load is balanced.
• During the spin process, if clothes are piled to one side of the
tub, your washer may stop because of the imbalance. Your
washer tries up to three times to solve the problem
automatically. If your washer can’t solve the problem, try to
manually redistribute clothes inside the tub.
Washer stops • Make sure that the power outlet is a working outlet.
• Close the lid, then press the (start/pause) button to start
your washer. For your safety, your washer doesn’t spin unless
the lid is closed.
• Before your washer starts to fill, it makes a series of clicking
noises to make sure that the lid is locked and to do a quick
drain.
• Sometimes your washer may pause between stages in the
cycle. Wait to see if your washer starts again.
• Disconnect the inlet hoses and clean the hose filter screens
periodically. The screens may be clogged.
Lid is locked or
doesn’t open
• Press the (start/pause) button to pause your washer. You
can’t open the lid if your washer is running.
• After you pause your washer, it may take a few seconds for the
lid lock to release.
• If the lid is locked when your washer isn’t running, press the
(power) button to turn on your washer.
• If power fails while your washer is running, the lid unlocks
when power is restored. Your washer waits three minutes, then
runs the rest of the cycle.
Washer doesn’t
drain or spin
• Close the lid, then press the (start/pause) button to start
your washer. For your safety, your washer doesn’t spin unless
the lid is closed.
• Make sure that the drain hose isn’t kinked. Straighten as
necessary.
• Make sure that the height of the drain hose is within specified
limits. See Drainage requirements on page 19.
• Check the fuse or reset the circuit breaker.
• The pipes to your sewer system may be clogged. Contact a
plumber or qualified repair professional.
PROBLEM SOLUTION
Loading ...
Loading ...
Loading ...