Loading ...
Loading ...
Loading ...
USER MAINTENANCE INSTRUCTIONS
35
www.insigniaproducts.com
3 Turn the cycle selector to Tub Clean.
4 Press the (start/pause) button.
Storing your washer
You can damage your washer if you don’t remove water from hoses and internal
components before storage.
1 Select the Quick Wash cycle and add bleach to your washer. Run your washer
through the cycle without a load.
2 Turn the water faucets off and disconnect the inlet hoses.
3 Unplug your washer from the electrical outlet and leave your washer’s lid
open to let air circulate inside the tub.
4 Raise the drain hose vertically to make sure that all the water has been
drained.
Troubleshooting
WARNING:
Certain internal parts are intentionally not grounded and may present a risk of
electric shock only during servicing. Service Personnel: Do not contact the
following parts while the appliance is energized:
•Electric
•Valve
•Retractor
• Motor pump.
CAUTION:
If your washer has been stored in below-freezing temperatures, allow time for
any leftover water in your washer to thaw out before use.
CAUTION:
Don’t try to repair your washer yourself. Doing so invalidates the warranty.
PROBLEM SOLUTION
Washer doesn’t
start
• Make sure that your washer is plugged in.
• Make sure that the lid is closed.
• Make sure that the water source faucets are open.
• Make sure that you press the (start/pause) button to start
your washer.
• Before your washer starts to fill, it makes a series of clicking
noises to make sure that the lid is locked and to do a quick
drain.
• Check the fuse or reset the circuit breaker.
Loading ...
Loading ...
Loading ...