Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
18
www.insigniaproducts.com
• Gap between the end of the water valve and the wall:
• Case 1: If you connect the supply hose after you install your washer: Over
3.9 in. (10 cm)
• Case 2: If you connect the supply hose before you install your washer: Over
2.8 in. (7 cm)
If you install your washer and dryer side-by-side in a closet, the closet front must
have an unobstructed air opening of at least 72 sq. in. (465 sq. cm).
Electrical requirements
Use a 120 Volt, 60 Hz, 15 amp fuse or circuit breaker. We recommend an individual
branch circuit that serves only your washer.
WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS on page 3 before operating your washer.
WARNING:
Never use an extension cord.
WARNING:
Certain internal parts are intentionally not grounded and may present a risk of
electric shock only during servicing. Service Personnel: Do not contact the
following parts while the appliance is energized:
•Electric
•Valve
•Retractor
• Motor pump.
27 in. (68.6 cm)
1 in.
(2.5 cm)
1 in.
(2.5 cm)
2 in.
(5.1 cm)
24 in. (61 cm)
6 in.
(15.2 cm)
25 in. (64 cm)
Loading ...
Loading ...
Loading ...