Loading ...
Loading ...
Loading ...
21
B- Changing Remote Batteries
Remote Battery Replacement (1-button)
Replace remote battery with a CR2032 coin cell battery.
1. Slide the battery cover o.
2. Slide out the old battery and slide in the new. Be sure positive side (+) is UP.
3. Slide the battery cover on until it snaps into place.
Remote Battery Replacement
(3-button)
Replace remote battery with a CR2032 coin cell battery.
1. Open remote case using a washer or coin that ts into the slot on the top of the remote.
2. Replace battery.
Be sure positive side (+) is UP.
3. Align components and snap case closed.
1. Disconnect power to opener.
2. Open powerhead lens covers by pressing down on upper locking tabs and pull away from powerhead.
3. Replace old light bulbs with 60 Watt MAXIMUM incandescent, CFL or LED equivalent**.
* Genie LED light bulbs, which are specically made for garage door openers, are recommended.
4. Install lens cover(s).
5. Reconnect power to door opener.
6. Test light operation.
NOTE: Use of standard LED bulbs may reduce the range of your remote controls*.
WARNING
!
• Use extreme caution when working from a ladder or step
stool or serious injury can occur.
• When replacing light cover, make sure wires are not
pinched or near moving parts.
• Use only properly rated incandescent, LED or CFL light
bulbs.
• DO NOT use bulbs with a rating greater than 60 Watts.
• Use A19 size light bulbs. DO NOT use bulbs having a short
neck.
AVERTISSEMENT
!
• Faire particulièrement attention lors de travaux eectués
depuis une échelle ou en escabeau.
• En referment le couvercle de l’éclairage, s’assurer que les
ls ne sont ni coincés ni près des pièces mobiles.
• Utilisez uniquement incandescence correctement classé,
LED ou des ampoules uocompactes.
• NE PAS utiliser des ampoules avec une note supérieure à
60 Watts
• Utilisez A19 ampoules de taille. NE PAS utiliser des
ampoules ayant un cou court.
*GenieLEDlightbulbsaredesignedtoreduceoreliminate
reducedremoterangeissuescausedbycommonLED
bulbs.Theyalsooerbetterproductlifebymakingthem
resistanttovibrationcausedbytheopener,andcoldor
dampweather.Seewebsitefordetailsat
www.geniecompany.com.
**Integrated Aladdin Connect® models require a MINIMUM 40 Watt or
equivalent bulb, 60 watt maximum.
Models equipped with integrated LED lighting require specialty kits available for
order in the replacement parts section.
C - Changing Lightbulbs
Push down tabs
Pull light covers away from powerhead
Push down tabs
Pull light cover away from powerhead
1 Light Models 2 Light Models
Loading ...
Loading ...
Loading ...