Loading ...
Loading ...
Loading ...
18
Installing Battery Backup
Installing the Battery Backup:
For units that included optional battery backup (BBU)
1. Unplug powerhead from power source.
2. Dualbulbmodels: Tilt BBU approximately 450 and lower into slots in the top rear of the
powerhead.
3. Fasten to powerhead with 2 supplied self tapping screws.
NOTE: There are no holes in rear cover. Self Tapping screws will self tap through cover.
• Singlebulbmodels: Attach BBU assembly next to the opener and install mounting screws to
ceiling or framing.
4. Plug battery harness into plug located at the top of the
powerhead.
5. Reconnect powerhead to power source.
45
Testing The Genie Battery Backup
NOTE: It is recommended that the battery backup be allowed to charge for 48 hours prior to testing.
Initially, the opener may not operate from the battery backup mode if battery is not fully charged.
NOTE: Opener will run at a reduced speed when operating from battery backup.
1. Run the opener using the wall control or remote to ensure it is working properly.
2. Turn o power to opener by unplugging from outlet or turning o breaker.
3. Press wall control or remote control. Opener will run at a slower speed than normal.
NOTE: See troubleshooting guide in this manual if any of the steps above fail.
Work light will not operate while in battery backup mode. (Courtesy white LED’s will illuminate.)
4. After successful test, reconnect powerhead to power source.
See the troubleshooting section for condition LED’s that will illuminate once
the Battery Backup is operational.
BothLEDswillsignalsolidGREENundernormal,fullycharged,conditions.
TO PREVENT POSSIBLE
SERIOUS INJURY or DEATH
from electrocution AND REDUCE RISK of FIRE
— Disconnect ALL electric power sources and battery
power BEFORE performing ANY service or maintenance.
Install only in DRY locations - NOT INTENDED FOR OUTDOOR USE.
Use only 12V, 5AH, SLA replacment battery
(P/N 111658.0002.S).
CAUTION
Installer uniquement dans des endroits secs—NE DOIT PAS ÊTRE
UTILISÉ À L'EXTÉRIEUR.
Utiliser uniquement une pile de remplacement de 12V, 5AH, SLA
(réf. 111658.0002.S).
POUR ÉVITER LES BLESSURES
GRAVES VOIRE MORTELLE PAR
ÉLECTROCUATION POUR RÉDUIRE ES LES RISQUES
D'INCENDIE
—Débrancher toutes les sources d’alimentation électriques et
la pile avant d'eectuer des opérations de réparation ou
d'entretien.
ATTENTION
Battery backup devices from other manufacturers will not operate with this opener.
Use only Genie Battery Backup type battery that was provided. Genie P/N 111658.0002.S (Battery only)
Perform these steps only after opener is fully installed, programmed and
tested.
Dual Bulb Models
Single Bulb Models
Loading ...
Loading ...
Loading ...