Loading ...
Loading ...
Loading ...
12
PROGRAMMING VEHICLE CONTROLS (abbreviated)
A. Press the chosen HomeLink button for two seconds and
release. Press that same button again for two seconds and
release. The long LED will ash blue and then turn o.
B. Press the HomeLink button a few more times until door
moves.
NOTE:
For additional instructions, see the motor
vehicle manual, or visit www.homelink.com or visit
www.geniecompany.com
Step 1) Clear HomeLink
Clear HomeLink by pressing and holding down the rst and
third buttons until the indicator on
the HomeLink blinks slow and then
fast for 20 seconds; then release
both buttons.
NOTE: Clearing the HomeLink
will remove all previously programmed garage door
openers.
Step 2) Train HomeLink to the Remote
Choose the button on the HomeLink that will be used to open
the door.
NOTE:
Hold the Remote two inches from the HomeLink
button.
Hold down the remote button.
While holding, press and hold the
chosen HomeLink button.
Hold down both buttons until the indicator on the HomeLink
blinks slow then fast. Once it blinks, release both buttons.
Programming HomeLink® System Programming Car2U
®
System
Step 1) Clear Car2U to default settings
The default setting for the Car2U system is:
•Button1=Genie®ManufacturedOpeners
•Button2=LiftMaster®Manufactured
Openers
•Button3=WayneDalton®ManufacturedOpeners
A. Press and hold buttons 1 and 3 for 20 seconds or until all
three LEDs begin to ash.
B. Release both buttons. The Car2U system is now set to the
Factory Default settings
NOTE:
Clearing the Car2U remote will remove all previously
programmed garage door openers.
Step 2) Program Car2U to the Opener
(Place opener into programming mode) - SEE PAGE 9
A. Press the designated Car2U button for two
seconds and release. Press that same button
again for two seconds and release. The long LED
will ash blue and then turn o.
B. Press the Car2U button a few times more until door moves.
Step 3) Program HomeLink to the Opener
(Place opener into programming mode) - SEE PAGE 9
Step 3) Changing Factory Default Button for a Genie® Opener
A. Press and hold buttons 1 & 3 for ONE SECOND
and release—all three LEDs will light solid red.
B. Press and hold the button (2 or 3) to change
it to—the corresponding LED will ash. While
continuing to hold that button, press and release
button 1. Press and release button 1 again.
C. Release the button being held in step B and wait
for the LED to stop ashing. This button is now
set. Repeat Step 2 for second Opener.
NOTE:
For additional instructions see the motor vehicle
manual, learcar2u.com.
Loading ...
Loading ...
Loading ...