Loading ...
Loading ...
Loading ...
11
PROGRAMMING KEYPAD (abbreviated)
Program Keypad before mounting.
Activate keypad by opening battery
compartment and pull protective
tab. Reinstall compartment door to
begin programming.
TAB
STEP 1) PROGRAMMING A PIN NUMBER (Single Door)
STEP 2) CHANGING DEFAULT PIN OF 3-5-7
Single Door Operation:
1. Ensure number pad back lighting is o.
2. Enter PIN number.
3. Press the UP/DOWN key.
4. Opener will operate.
STEP 3) OPERATING THE KEYPAD WITH THE OPENER
NOTE: Keypad will remain active for 15 seconds after
a successful entry is made. During this 15 seconds ANY
key will operate the opener.
QuickViewSingleDoorsetup.
Please see complete instructions that accompany keypad
Resetting a PIN:
Press and hold both the PROGRAM key and the Up/
Down key for about ve seconds.
The LED’s will slowly blink and then go out. When the
LED stops blinking, the old programming has been
successfully erased.
To create a new PIN, start with STEP 1.
Mounting Keypad
The keypad MUST be mounted within sight of the
garage door(s) at least ve feet above the oor and
clear of any moving door part.
1. Remove battery cover and batteries.
2. Drill 3/32” pilot hole for the top mounting screw
(included).
3. Install a screw into the pilot hole, leaving a 1/8” gap
between the screw head and wall.
4. Hook the slotted mount, on back of keypad, over
the screw.
5. Mark and drill a pilot hole for the bottom screw
(included) and secure keypad to wall (DO NOT
overtighten).
6. Reinstall batteries and cover.
1. Enter the factory default pin of 3-5-7.
2. Press PROGRAM key once.
3. Enter a new PIN of your choice (3-8 digits).
4. Press PROGRAM key once.
• Your PIN has been changed and your previous PIN
will no longer operate the keypad or opener.
The existing factory default Personal Identication
Number (PIN) for this keypad is the number sequence:
3-5-7
Sync the opener and the keypad by performing the
following:
1. Ensure the keypad back lighting is o.
2. Place garage door opener into remote control
PROGRAMMING MODE (SEE PAGE 9).
3. Press 3-5-7 in sequence on the keypad.
4. Press the UP/DOWN key 3 to 4 times slowly until
garage door opener operates.
•This completes the programming of a single door
opener (door 1) and keypad.
•IT IS RECOMMENDED THAT YOU CHANGE THIS PIN
FROM THE EXISTING FACTORY DEFAULT SETTING of
3-5-7. See STEP 2 below.
Loading ...
Loading ...
Loading ...