Loading ...
Loading ...
Loading ...
20
Regular inspection/maintenance for the door and opener should be
performed at regular intervals to ensure the system runs at peak safety,
performance and eciency.
MAINTENANCE ITEM INTERVALS DETAILS
Contact Reverse Test Monthly See Page 8 to run system test.
Lubricate Door
Hardware
Monthly Lubricate Rollers & Hinges with a light weight general
purpose grease.
Safe-T-Beam® system
check
Monthly Check wiring for loose connections, cracks or worn
insulation.
Clean lenses of dirt & debris.
Door Balance Monthly See Maintenance Detail A
Battery Backup System Monthly Unplug opener from outlet. Test opener with remote or
wall console. Replace battery if needed. See page 20.
Chain/Belt
Adjustments
Yearly Inspect chain/belt for excessive slack, adjust as
necessary.
Remote Battery
replacement
As Needed See Maintenance Detail B
Light Bulb
Replacement
As Needed See Maintenance Detail C
PerformtheDoorinspectionasfollows:
With the door closed, pull manual emergency release handle DOWN and away from door and let go to disengage the
carriage from the drive chain or belt FIG.1.
• Raise and lower the door manually. Door should move freely and smoothly.
• Raise door manually about 3’ to 4’ feet from oor and let go.
. Door should remain stationary or slowly drift
closed. FIG. 2.
If door opens or closes rapidly, CONTACT A TRAINED DOOR SYSTEM TECHNICIAN to have your door springs
serviced.
• Close the door.
• Place the carriage in the “engage” position Reverse of FIG. 1.
• Operate door using remote or wall control. The carriage will reattach itself to the drive chain/belt.
A - Door Inspection
FIG.1 FIG 2
WARNING
!
• Garage door hardware (springs, cables, brackets, pulleys, etc.) are under
extreme pressure and tension.
• DO NOT attempt to repair or adjust door springs or any hardware, and
DO NOT OPERATE garage door automatically or manually if door is
improperly balanced or springs are broken.
• CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.
AVERTISSEMENT
• La quincaillerie de la porte de garage (ressorts, câbles, supports,
poulies, etc.) sont sous des pressions et des tensions extrêmes.
• NE PAS réparer ni régler les ressorts de la porte ou toute autre pièce
de quincaillerie et NE PAS ACTIONNER la porte manuellement ou
automatiquement si elle n’est pas correctement équilibrée ou si des
ressorts sont cassés.
• CONTACTEZ UN TECHNICIEN SPéCIALISé EN SYSTÈME DE PORTES
DO NOT use release cord to pull door.
Chain/Belt Drive CHANNEL
Disengage the carriage by pulling
the release handle down, toward
the door and then releasing
Chain/Belt Drive TUBE RAIL
Disengage the carriage by pulling
the release handle down, then
releasing
!
Loading ...
Loading ...
Loading ...