Loading ...
Loading ...
Loading ...
6
Installation
Select Location
The proper location will ensure peak
performance of your appliance. We
recommend a location where the ice
machine will be out of direct sunlight
and away from heat sources. To ensure
your product performs to specifications,
the recommended installation location
temperature range is from 55 to 90°F (13
to 32°C) for built in ice machines and 55
to 100°F (13 to 38°C) for freestanding ice
machines. Ice machines will not perform
correctly in ambient temperatures less
than 55°F (13°C). This unit is not intended
to be installed outdoors.
Cabinet Clearance
Ventilation is required from the bottom
front of the appliance. Keep this area open
and clear of any obstructions. Adjacent
cabinets and counter top can be installed
around the appliance as long as the front
grille remains unobstructed.
CAUTION
Do not obstruct the front grille. The
openings within the front grille allow
air to flow through the condenser
heat exchanger. Restrictions to this
air flow will result in increased energy
usage and loss of cooling capacity.
For this reason it is important this
area not be obstructed and the grille
openings kept clean. Electrolux does
not recommend the use of a custom
made grille as air flow may be
restricted (Figure 1).
Figure 1
Front Grille,
keep this area
open
Rear
Leveling
Legs
Front Leveling
Legs
CAUTION
PLEASE READ all instructions
completely before attempting to
install or operate the unit. Plumbing
installation must observe all state and
local codes. All ice makers require
a connection to the water supply
and improper hook-up can result
in substantial property damage! All
water and drain connections MUST
BE made by a licensed/qualified
plumbing contractor. Failure to follow
recommendations and instructions
may result in damage and/or harm.
Drain Plumbing
Your ice machine requires drain plumbing.
Follow these guidelines when installing
drain lines to prevent water from flowing
back into the ice maker storage bin and/
or potentially flowing onto the floor causing
water damage.
CAUTION
Observe and follow all local building
codes when installing this ice
machine and drain lines.
C
L
C
L
14
7
⁄8"
(37.8 cm)
11
⁄16"
(17mm)
1
1
⁄4"
(3.2 cm)
4
17
⁄32"
(11.5 cm)
21
1
⁄2"
(54.6 cm)
Water
supply
inlet
Drain access in
bottom of unit
(if using gravity
drain)
4
3
⁄32"
(10.4 cm)
Figure 2
Installing the Drain
CAUTION
Failure to use an adequate drainage
system, will result in surrounding
water damage and/or poor ice
production.
Loading ...
Loading ...
Loading ...