Loading ...
Loading ...
Loading ...
11
Door Adjustment
4 If door edge opposite the hinges
needs to move up, move plate
toward outside of door. If door edge
needs to move down, move plate
toward inside of door. Repeat until
top edge of door is parallel with
top of cabinet and tighten screws
securely.
5 After adjustment is complete, remove
the door closers from the bottom
hinge, clean thoroughly and apply
petroleum jelly to the mating surfaces
of the closers (Figure 3). Be sure that
bosses on closers align with holes in
hinge and hinge plate. Mount door
and install top hinge pivot pin.
Adjusting the Door
Your door is aligned at the factory before
shipment. Occasional re-adjustment may
be necessary, especially if an overlay panel
is installed. The following procedure will
correct for up to 1/4” alignment.
The door should never be flush with the
top of the cabinet. Even when level, the
top edge of the door will be 1/8” below the
top of the cabinet (Figure 1).
Figure 3
Door
Closer
Inserts
Boss
Figure 2
1/8" Allen
Wrench
Figure 1
1/8"
To adjust :
1 Compare the top edge of the door
(opposite the hinges) to the top edge
of the cabinet and note the type of
adjustment (up or down) needed.
2 Remove the top hinge pivot pin with
a 1/8" Allen wrench (Figure 2) and lift
door off bottom hinge pin. Be careful
not to lose door closers (Figure 3).
3 With door upside-down, loosen but do
not remove the two hinge plate screws.
Loading ...
Loading ...
Loading ...