Loading ...
Loading ...
Loading ...
19
Maintenance
To remove and replace the grille for access
to the condenser, follow this procedure
(Figure 1):
1 Loosen the two Phillips head screws,
one at each end of the grill. It is not
necessary to remove them.
2 With the door open, raise up on the
end of the grille opposite the hinges
and pull toward you to remove the
screw from the keyhole slot in the grille.
3 Pull the grille to the side to remove
the grille.
Condenser Cleaning —
Every 3 Months
To maintain operational efficiency, clean the
condenser every three months (depending
on environmental conditions, more or less
frequent cleaning may be necessary).
Automatic Cleaning —
Every 6 Months
To maintain operational efficiency, clean the
unit every six months (depending on water
conditions more or less frequent cleaning
may be necessary). If the ice maker requires
more frequent cleaning, consult a qualified
plumber to test the water quality and
recommend appropriate treatment.
Ice machine cleaner is used to remove
lime scale and other mineral deposits.
Refer to the following steps for mineral
deposit removal.
WARNING
Disconnect electric power to the ice
maker before cleaning the condenser.
WARNING
DO NOT touch the condenser. The
ends of the wires are sharp and can
also be easily damaged.
CAUTION
DO NOT use any type of cleaner on
the condenser unit.
WARNING
Wear rubber gloves and safety
goggles and/or face shield when
handling Ice Machine Cleaner.
CAUTION
It is a violation of Federal law to use
this solution in a manner inconsistent
with its labeling.
Read and understand all labels
printed on the package before use.
CAUTION
Never use anything to force ice from
the evaporator. Damage may result.
IMPORTANT
• Discard all ice produced during
the first 3 hours of operation after
cleaning.
• If power gets interrupted during the
self-clean cycle, it will be necessary
to repeat the complete cleaning
cycle after power is restored.
Figure 1
Rear of grille
Keyhole slot
in grille
Screw slot in grille
Access to the phillips head
screws is through the top
end slots in the front of
the grille
4 Clean the condenser coil using a
brush with a "combing" action or a
vacuum cleaner. Do not touch the
condenser coil.
5 Clean the grille, then position the grille
over the screws in the cabinet.
6 Tighten the grille screws.
Loading ...
Loading ...
Loading ...