Loading ...
Loading ...
Loading ...
20
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
: Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
1. Switch off the fuse in the fuse box or unplug at the mains.
2. Turn the cover anti-clockwise to remove.
3. Remove the bulb and replace with a bulb of the same type.
4. Slide the new seals and the clamping ring onto the glass
cover in the right order.
5. Screw the glass cover with the seals back on again.
6. Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
The water tank drains for no discernible
reason. The evaporator dish is overflowing
The water tank was not closed properly Close the lid until you feel it engage
The tank lid seal is dirty Clean the seal
The seal in the tank cover is defective Obtain a new water tank from the after-
sales service
Liquid in the evaporator dish has fully
evaporated, even though the water tank is
full.
The water tank has not been inserted
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance. Check whether the
water hardness range is set correctly
The
Î indicator appears
The appliance has not been used for at
least two days and the water tank is full
Empty and clean the water tank. Always
empty the water tank after cooking
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam
This is normal.
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal.
When cooking with steam, a lot of steam is
produced repeatedly
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Restore the appliance to the factory set-
ting (see section: Basic settings). Then
start
é Steam cooking at 100 °C for
20 minutes
Steam escapes from the ventilation slots
during cooking
This is normal.
The appliance is not producing steam
properly
Limescale has formed in the appliance Descale the appliance (see section: Des-
caling).
Error message
“‹‚‚ appears in the tem-
perature display
A button was pressed for too long or is
jammed
Press the
KJ clock function button to
delete the error message. Press all of the
buttons individually and check whether
they are clean
An error message
“‹... appears in the
temperature display
Technical fault
Press the KJ clock function button to
delete the error message, and reset the
clock if necessary. If the error message
appears again, call the after-sales service
The appliance is not heating. The colon is
flashing in the clock display. For example,
‚‹‹© appears in the temperature display
A button combination was activated Switch off the appliance.
Press and hold the
± info button for
3 seconds, then press and hold the
KJ
clock function button for 4 seconds, then
press and hold the
± info button for
3seconds
Problem Possible cause Notes/remedy
Loading ...
Loading ...
Loading ...