Loading ...
Loading ...
Loading ...
09 Wheels and tyres
09
}}
357
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
3. Make sure the compressor is switched
off. Detach the air hose and cable.
Fit the valve cap.
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid
damage to the valve from gravel, dirt,
etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
NOTE
The sealing fluid bottle and the hose must
be replaced after use. Volvo recommends
that this replacement is performed by an
authorised Volvo workshop.
WARNING
Check the tyre pressure regularly.
Volvo recommends that the car is driven to
the nearest authorised Volvo workshop for
the replacement/repair of the damaged tyre.
Advise the workshop that the tyre contains
sealing fluid.
WARNING
You should not drive faster than 80 km/h
after the emergency tyre repair kit has
been used. Volvo recommends a visit to
an authorised Volvo workshop for inspec-
tion of the sealed tyre (maximum driving
distance is 200 km). The staff there can
determine whether or not the tyre can be
repaired or if it needs to be replaced.
Related information
•
Emergency puncture repair (p. 352)
•
Emergency puncture repair - operation
(p. 354)
•
Emergency puncture repair kit - overview
(p. 354)
Emergency puncture repair kit -
inflating the tyres
The car's original tyres can be inflated using
the compressor in the emergency puncture
repair kit (p. 354).
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the
bottom of the thread on the tyre's air
valve.
WARNING
Inhaling car exhaust fumes could result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suf-
ficient ventilation.
WARNING
Do not leave children in the car without
supervision when the engine is running.
3. Connect the cable to one of the car's
12 V sockets and start the car.
4. Start the compressor by flicking the
switch to position I.
Loading ...
Loading ...
Loading ...