Loading ...
Loading ...
Loading ...
08 Starting and driving
08
}}
* Option/accessory, for more information, see Introduction.
273
Alcohol lock* - to bear in mind
In order to obtain correct function and as
accurate a measurement result as possible:
•
Avoid eating or drinking
approx. 5 minutes before the breath test.
•
Avoid excess windscreen washing - the
alcohol in the washer fluid may result in
an incorrect measurement result.
Change of driver
In order to ensure that a new breath test is
carried out in the event of a change of driver -
depress the switch (2) and the send button (3)
simultaneously for approx. 3 seconds. At
which point the car returns to start inhibition
mode and a new approved breath test is
required before starting the engine.
Calibration and service
The alcohol lock must be checked and cali-
brated at a workshop
1
every 12 months.
30 days before recalibration is necessary the
combined instrument panel shows the mes-
sage
Alcoguard Calibration required See
manual. If calibration is not carried out within
these 30 days then normal engine starting will
be blocked - only starting with the Bypass
function will then be possible, see the follow-
ing heading "Emergency situation".
The message can be cleared by pressing the
send button (3) once. Otherwise it extin-
guishes on its own after approx. 2 minutes
but then reappears each time the engine is
started - only recalibration at a workshop
1
can clear the message permanently.
Cold or hot weather
The colder the weather the longer it takes
before the alcohol lock is ready for use:
Temperature (ºC) Maximum heat-
ing time (sec-
onds)
+10 to +85 10
-5 to +10 60
-40 to -5 180
At temperatures below -20 ºC or above
+60 ºC the alcohol lock requires additional
power supply. The combined instrument
panel shows
Alcoguard Please insert
power cable. In which case, connect the
power supply cable from the glovebox and
wait until indicator lamp (6) is green.
In extremely cold weather the heating time
can be reduced by taking the alcohol lock
indoors.
Emergency situation
In the event of an emergency situation or the
alcohol lock is out of order, it is possible to
bypass the alcohol lock in order to drive the
car.
NOTE
All Bypass activation is logged and saved
in memory, see Recording data (p. 18).
After the Bypass function has been activated
the combined instrument panel shows
Alcoguard Bypass enabled the whole time
while driving and can only be reset by a work-
shop
1
.
The Bypass function can be tested without
the error message being logged - in which
case, carry out all the steps without starting
the car. The error message is cleared when
the car is locked.
When the alcohol lock is installed, either the
Bypass or Emergency function is selected as
the bypassing option. This setting can be
changed afterwards at a workshop
1
.
Activating the Bypass function
•
Depress and hold the left-hand stalk
switch OK button and the button for haz-
ard warning flashers simultaneously for
approx. 5 seconds - the combined instru-
ment panel first shows
Bypass activated
1
An authorised Volvo workshop is recommended.
Loading ...
Loading ...
Loading ...