Loading ...
Loading ...
Loading ...
||
08 Starting and driving
08
280
* Option/accessory, for more information, see Introduction.
Related information
•
Remote start (ERS)* (p. 277)
•
Remote start (ERS) - operation (p. 277)
Jump starting with battery
If the starter battery (p. 390) is discharged
then the car can be started with current from
another battery.
When jump starting the car, the following
steps are recommended to avoid short cir-
cuits or other damage:
1. Set the car's electrical system in key
position 0, see Key positions - functions
at different levels (p. 81).
2. Check that the donor battery has a volt-
age of 12 V.
3. If the donor battery is installed in another
car - switch off the donor car's engine
and make sure that the two cars do not
touch each other.
4. Connect one of the red jump lead's
clamps to the donor battery's positive
terminal (1).
IMPORTANT
Connect the start cable carefully to avoid
short circuits with other components in the
engine compartment.
5. Open the clips on the front cover of the
battery in your car and remove the cover,
see Starter battery - replacement
(p. 392).
6. Connect the red jump lead's other clamp
onto the car's positive terminal (2).
7. Connect one of the black jump lead's
clamps to the donor battery's negative
terminal (3).
8. Connect the other clamp to a grounding
point, e.g. right-hand engine mounting at
the top, the outer screw head (4).
9. Check that the jump lead clamps are
affixed securely so that there are no
sparks during the starting attempt.
10. Start the engine of the "donor car" and
allow it to run a few minutes at a speed
slightly higher than idle
approx. 1500 rpm.
Loading ...
Loading ...
Loading ...