Loading ...
Loading ...
Loading ...
USA
Instructions for the Installer
39
16 INSTALLATION INSTRUCTIONS
Before installation
Check that the input voltage indicated on the rating plate is the
same as the voltage of the power outlet you are going to use.
If required by the National Electrical Code (or Canadian Electrical
Code), this appliance must be installed on a separate branch
circuit.
Installer – show the owner the location of the circuit breaker or
fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel. Lock service
panel to prevent power from being turned ON accidentally.
Be sure your appliance is properly installed and grounded by a
qualified technician. Installation, electrical connections and
grounding must comply with all applicable codes.
Open the oven door and take out all the accessories and remove
the packing material.
Do not remove the mica cover on the ceiling of the interior! This
cover stops fat and pieces of food damaging the microwave
generator.
Warning! The front surface of the oven may be wrapped with a
protective film. Before using the oven for the first time, carefully
remove this film, starting on the inside.
Make sure that the oven is not damaged in any way. Check that
the oven door closes correctly and that the interior of the door and
the front of the oven opening are not damaged. If you find any
damage contact the Technical Assistance Service.
DO NOT USE THE OVEN if the metal conduit is damaged, if the
oven does not function correctly or if it has been damaged or
dropped. Contact the Technical Assistance Service.
Place the oven on a flat and stable surface. The oven must not be
put close to any sources of heat, radios or televisions.
Electrical supply
Before installing the oven have a qualified electrician verify that
your home is provided with adequate electrical service and that the
addition of the oven will not overload the branch circuit on which it
is to be installed.
A separate three-wire or four-wire single phase, 240 Volt, 60 Hz,
branch circuit is required.
For hook-up of the oven you will need to have an approved
junction box installed where it will be easily reached through the
Loading ...
Loading ...
Loading ...