Loading ...
Loading ...
Loading ...
Self-help
●
Pr
ess and hol
d release button
›››
Fig. 48
1
and pull gently on the wiper blade in the di-
r
ection of the arr
ow.
●
Fit a new wiper blade of the same length
and design on to the wiper arm and hook it
into place.
●
Rest the wiper arms back onto the wind-
screen.
Changing the rear window wiper blade
●
Separate the wiper arm from the rear win-
dow.
●
Remove the blade from the holder below
the centre. During this operation, hold the
wiper arm firmly.
●
Fit the new blade (of the same length and
type) into the housing of the wipe arm by
pressing it in place. When doing so, hold the
wiper arm by the upper end.
●
Fold the wiper arm and rest it on the win-
dow.
WARNING
Worn or dirty windscreen wiper blades re-
duce visibility and incr
ease the risk of acci-
dent and serious injury.
●
Always replace damaged or worn wind-
screen wiper blades or blades that no lon-
ger clean the windscreen properly.
CAUTION
●
Damaged or dirt
y windscreen wipers
could scratch the glass.
●
If products containing solvents, rough
sponges or sharp objects are used to clean
the blades, the graphite layer will be dam-
aged.
●
Never use fuel, nail varnish remover, paint
thinner or similar products to clean the win-
dows.
●
In icy conditions, always check that the
wiper blades are not frozen to the glass be-
fore using the wipers. In cold weather, it
may help to leave the vehicle parked with
the wipers in service position
›››
page 52.
CAUTION
●
To pr
event damage to the bonnet and the
wiper arms, only leave them in the service
position.
●
Before driving, always lower the wiper
arms.
Jump start
Jump l
eads
The jump lead must have a sufficient wire
cr
oss section.
If the engine f
ails to start because of a dis-
charged battery, the battery can be connec-
ted to the battery of another vehicle to start
the engine.
Jump leads must comply with standard DIN
72553 (see cable manufacturer's instruc-
tions). The wire cross section must be at least
25 mm
2
for petrol engines and at least
35 mm
2
for diesel engines.
Note
●
The vehicl
es must not touch each other,
otherwise electricity could flow as soon as
the positive terminals are connected.
●
The discharged battery must be properly
connected to the on-board network.
53
Loading ...
Loading ...
Loading ...