Loading ...
Loading ...
Loading ...
Practical tips
●
Wheel rims may be damaged or scrat
ch-
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Tyre pressure monitor sys-
tem
Contr
ol lamp
It lights up
The inflation pressure of one or more wheels is much
lo
wer than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text
message is displayed on the instrument panel
screen.
Stop the vehicle! Stop the vehicle safely as soon
as possible. Check all tyres and pressures. Replace
any damaged tyres.
Flashes
System fault
The control l
amp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure monitor
indicator
›››
page 346. If the fault continues, go to a
specialised workshop.
Several control and warning lamps light up
f
or a f
ew seconds when the ignition is switch-
ed on while the function is verified. They will
switch off after a few seconds.
WARNING
Observe the safety warnings
››
›
in Con-
trol and w
arning lamps on page 88.
Tyre pressure monitor system
Fig. 236
Instrument panel: warning of loss of
t
yr
e pressure.
The tyre pressure monitoring system com-
par
es the individual speeds of each wheel
and thus the dynamic r
adius with the help of
the ABS sensors.
If the rolling circumference of one or more
wheels has changed, the tyre pressure moni-
toring indicator will indicate this on the instru-
ment panel through a warning lamp and a
warning to the driver
›››
Fig. 236. When only
one specific tyre is affected, its position within
the vehicle will be indicated.
Loss of pressure: Check left
tyre pressure!
Wheel tread change
The wheel diameter changes when:
●
Tyre pressure is changed manually.
●
Tyre pressure is insufficient.
●
The tyre structure is damaged.
●
The vehicle is unbalanced because of a
load.
●
The wheels on an axle are subject to a
heavier load (e.g. with a heavy load).
●
The vehicle is fitted with snow chains.
●
The temporary spare wheel is fitted.
●
The wheel on one axle is changed.
There may be a delay in the reaction of the
tyre pressure monitoring indicator or it may
not indicate anything under certain circum-
stances (e.g. sporty driving, snow-covered or
unpaved roads, or when driving with snow
chains).
Calibrate the tyre pressure monitoring in-
dicator
After changing the tyre pressure or replacing
one or more wheels, the tyre pressure moni-
toring indicator must be recalibrated. Do the
346
Loading ...
Loading ...
Loading ...