Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 353
Metric Speed (km/h)
• Pushing the SET (-) but
ton once will result in a 1 km/h
decrease in set speed. Each subsequent tap of the button
results in a decrease of 1
km/h.
• If the button is continually pushed, the set speed will
contin
ue to decrease until the button is released, then the
new set speed will be established.
To Accelerate For Passing
Press the accelerator as you would normally. When the pedal
is released, the vehicle will return to the set speed.
Using Speed Control On Hills
The transmission may downshift on hills to maintain the
vehicle
set speed.
NOTE:
The Speed Control system maintains speed up and down
h
ills.
A slight speed change on moderate hills is normal.
On steep hills, a greater speed loss or gain may occur so it
may be p
referable to drive without Speed Control.
To Resume Speed
To resume a previously set speed, push the RES button and
release. Resume can be used at any speed above 20 mph
(32 km/h).
To Deactivate
A soft tap on the brake pedal, pushing the CANC (cancel)
button, or normal brake pressure while slowing the vehicle
will deactivate the speed control without erasing the set
speed from memory.
Pushing the on/off button or cycling the ignition to OFF,
erases
the set speed from memory.
WARNING!
Speed Control can be dangerous where the system
cannot m
aintain a constant speed. Your vehicle could go
too fast for the conditions, and you could lose control
and have an accident. Do not use Speed Control in heavy
traffic or on roads that are winding, icy, snow-covered or
slippery.
5
Loading ...
Loading ...
Loading ...