Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 173
Training The Garage Door Opener
1. Place the ignition in the ON/RUN position.
2. Plac
e the hand-held transmitter 1 to 3 inche
s (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to
program
while you push and hold the hand-held trans-
mitter button.
4. C
ontinue to hold both buttons and observe the indicator
light.
The HomeLink indicator will flash slowly and then
rapidly after HomeLink has received the frequency signal
from the hand-held transmitter. Release both buttons
after the indicator light changes from slow to rapid.
5. At the garage door opener motor (in the garage), locate
the “L
EARN” or “TRAINING” button. This can usually
be found where the hanging antenna wire is attached to
the garage door opener/device motor. Firmly push and
release the “LEARN” or “TRAINING” button. On some
garage door openers/devices there may be a light that
blinks when the garage door opener/device is in the
LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the next step after
the LEA
RN button has been pushed.
6. Return to the vehicle and push the programmed Home-
Link bu
tton twice (holding the button for two seconds
each ti
me). If the garage door opener/device activates,
programming is complete.
1 — Door Opener
2 — Training Button
2
Loading ...
Loading ...
Loading ...