Loading ...
Loading ...
Loading ...
CLOCKWISE
to closed position
PRESET REGULATOR
WITH VAL
VE
S-L-O-W-L-Y Turn
LP Cylinder Valve ON
One Full T
urn counter-clockwise
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
S-L-O-W-L-Y Turn
Regulator Valve ON
counter
-clockwise to light
burner
21
TROUBLE SHOOTING GUIDE
SYMPTOM
Burner will not light
and burner tube is clean
Not enough gas flow from
propane tank
Open cylinder valve all the way,
then S-L-O-W-L-Y open regulator
valve to light burner
CAUSE POSSIBLE SOLUTION
Low gas level in propane tank,
or tank is empty
Check gas level in propane tank,
re-fill or exchange tank
Burner lights but the flame
remains very small
Rapid gas flow from propane
tank activates EXCESS FLOW
safety device
Repeat lighting instructions and
be certain to S-L-O-W
-L-Y open
cylinder valve one full turn, then
S-L-O-W-L-Y open regulator valve
to light burner
Burner will not light
Blockage in burner tube from
spider webs, insects, dirt
dobbers and debris
Disconnect hose from burner.
Clean and check burner tube for
spiders, insect nests and debris
Hissing or gurgling sounds
coming through regulator hose
assembly from tank to burner
Water in burner tube Check burner tube for moisture,
make sure burner is dr
y
Damaged hose
Perform Gas Leak Test to check hose
and all connections.
See pages 12 - 13 and follow the
instructions.
Gas leak
Flame has gone out
Low gas level in propane tank,
or tank is empty
Check gas level in propane tank
Too much wind Check wind direction and set
Fryer away from windy areas
NEVER move or adjust your fryer
while it is operating. T
ur
n it off
and let it cool first!
Do not use this appliance
if Gas Leak Test fails.
Problems with lighting the fryer:
LP Hose Regulator assemblies and propane tanks are equipped with a safety device
to reduce 90% of
gas flow should the hose be cut or severed. Sometimes this safety device may be activated when lighting
the fryer by opening the cylinder too fast. To prevent this, follow these steps:
TROUBLE SHOOTING TIPS
Prior to lighting, turn
regulator valve to the
CLOSED position.
1. 2. 3.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...