Loading ...
Loading ...
Loading ...
11
REGULATOR HOSE ASSEMBLY
The hose supplied with your fryer is Model #M5HPR-1.
It is designed to work with a LP Gas Cylinder and is a
T
ype-1 connection device with the following features:
1. The system will not allow gas flow from the cylinder
until a positive connection to the cylinder valve has been made.
NOTE: The cylinder valve must be turned off (clockwise)
before any connection is made or removed.
2. A flow limiting device, when activated, restricts the
flow of gas to 10 cubic feet per hour.
NOTE: the flow limiting device can be activated when
attempting to light fryer. If this occurs, refer to Trouble Shooting on page 21.
WARNING
• DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.
• DO NOT use any other pressure regulator/hose assembly than the
one supplied with your fryer.
• DO NOT attempt to adjust or repair the regulator.
• DO NOT attempt to disconnect the regulator hose assembly while fryer is in operation.
For connection to
LP Gas Cylinder
TYPE-1
Connector
Coupling Nut
Brass
Connector
For connection
to Fryer
Regulator Valve
A replacement regulator can be supplied by contracting Barbour International, Inc. at 1-800-864-6194.
Only use replacement regulator hose assembly #M5HPR-1. This regulator is designed to operate at a
maximum out put pressure of 10 psi (pounds per square inch).
CAUTION
The valve on the regulator hose assembly controls flame intensity ONLY. It is not an ON/OFF valve.
INSPECTING REGULATOR HOSE ASSEMBLY
The Regulator Hose Assembly is a pre-assembled unit. Do not take apar
t. Prior to each use, visually
inspect the regulator hose assembly. If there is evidence of abrasion, wear, cuts or leaks, the hose must
be replaced prior to the appliance being put into operation. To remove, use a wrench to loosen the brass
connector on the hose. To reattach, wrench tighten the brass connector back to the burner assembly.
Call 1-800-864-6194 for replacement Model #M5HPR-1. M-F 8am - 5pm CST.
Connect to Tank
(Clockwise)
Disconnect from Tank
(Counter
-Clockwise)
Decrease
Gas Flow
Increase
Gas Flow
Caution: The Regulator Valve
Controls the "Volume" of Gas
ONLY.
Use the Valve on the Propane Tank to
turn Gas Supply "ON" or "OFF".
PRESET REGULATOR
WITH SIDE VAL
VE
Turn Clockwise
Wrench Tighten
Light
BURNER
HERE
JET BURNER
Turn Counter-Clockwise
to Remove
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...