Loading ...
Loading ...
Loading ...
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
R
Replace the batteries in garage door remote
control A. This increases the likelihood that
garage door remote control A will transmit
a strong and precise signal to the integrated
garage door opener.
R
When programming, hold remote control A
at varying distances and angles from but-
tons ; to ? which you are programming.
Try various angles at a distance between
2and 8 inches (5to 20 cm) or at the same
angle but at varying distances.
R
If a further remote control A is available for
the same garage door drive, repeat the
same programming steps with this remote
control A. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote control
A.
R
Note that some remote controls only trans-
mit for a limited amount of time (the indica-
tor lamp on the remote control goes out).
Press button B on remote control A again
before transmission ends.
R
Align the antenna cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control. Please
also read the operating instructions for the
garage door system.
X
Turn the SmartKey to position 2 in the igni-
tion lock (Y page 126).
X
Press either button ;, = or ? which you
have programmed to operate the garage
door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code: indi-
cator lamp : flashes green.
The transmitter will transmit a signal as long
as the button is pressed. The transmission
is halted after a maximum of ten seconds
and indicator lamp : lights up yellow.
X
Press button ;, = or ? again if neces-
sary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
X
Turn the SmartKey to position 2 in the igni-
tion lock (Y page 126).
X
Press and hold buttons ; and ?.
The indicator lamp initially lights up yellow
and then green.
X
Release buttons ; and ?.
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
Compass
Calling up the compass
Compass ; displays the compass direction in
which the vehicle is currently traveling: NN, NENE,
EE, SESE, SS, SWSW, WW or NWNW.
To receive a correct display in rear-view mir-
ror :, the compass must be calibrated and
the magnetic field zone set.
262
Features
Stowage and features
Loading ...
Loading ...
Loading ...