Loading ...
Loading ...
Loading ...
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
X
To switch off the high-beam headlamps:
move the combination switch back to its
normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
Hazard warning lamps
X
To switch on the hazard warning lamps:
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the correspond-
ing side of the vehicle will flash.
X
To switch off the hazard warning lamps:
press button :.
The hazard warning lamps automatically
switch on if:
R
an air bag is deployed or
R
the vehicle decelerates rapidly from a speed
of above 45 mph (70 km/h) and comes to a
standstill
The hazard warning lamps switch off automati-
cally if the vehicle reaches a speed of above
6 mph (10 km/h) again after a full brake appli-
cation.
i
The hazard warning lamps still operate if
the ignition is switched off.
Cornering light function
The cornering light function improves the illu-
mination of the road over a wide angle in the
direction you are turning, enabling better visi-
bility in tight bends, for example. The corner-
ing light function can only be activated when
the low-beam headlamps are switched on.
Active:
R
if you are driving at speeds below 25 mph
(40 km/h) and switch on the turn signal or
turn the steering wheel
R
if you are driving at speeds between 25 mph
(40 km/h) and 45 mph (70 km/h) and turn
the steering wheel
The cornering lamp may remain lit for a short
time, but is automatically switched off after no
more than three minutes.
Cornering light function with traffic circle
function:
The cornering light function is activated on
both sides before entering a traffic circle
through an evaluation of the current GPS posi-
tion of the vehicle. It remains active until after
the vehicle has left the traffic circle. In this
way, pedestrians crossing the road, for exam-
ple, are illuminated by your vehicle in good
time.
Active light function
The active light function is a system that
moves the headlamps according to the steer-
ing movements of the front wheels. In this
way, relevant areas remain illuminated while
driving. This allows you to recognize pedes-
trians, cyclists and animals sooner.
Active: when the lights are switched on.
Vehicles with Lane Keeping Assist: the active
light function evaluates the course of the lane
in which you are driving and pre-emptively
controls the active light function.
Adaptive Highbeam Assist
General notes
You can use this function to set the headlamps
to change between low beam and high beam
automatically. The system recognizes vehicles
with their lights on, either approaching from
the opposite direction or traveling in front of
your vehicle, and consequently switches the
headlamps from high beam to low beam.
The system automatically adapts the low-beam
headlamp range depending on the distance to
the other vehicle. Once the system no longer
Exterior lighting
111
Lights and windshield wipers
Z
Loading ...
Loading ...
Loading ...