Loading ...
Loading ...
Loading ...
50
CLEANING THE DUST BIN
• Operating the unit without filters fitted to the dust bin can cause a motor malfunction
not covered by the warranty.
• After cleaning the dust bin, make sure to assemble the filter and fit it to the dust bin.
If the filters are not installed or the filter cover not assembled before cleaning is started,
an error message will sound.
• Always ensure that the dust bin lid is refitted correctly after
cleaning the dust bin so that it closes easily and accurately.
Tip
1. Open the dust bin compartment cover by
pressing the PUSH button on the Robot
Cleaner.
2. Grab the handle of the dust bin and pull it
upward.
3. Pull the hook on the left of the lter cover on
the rear of the dust bin to separate the lter
and the sponge.
※
Note that separating the lter may result in
dust dropping.
※
Refer to p.51 when cleaning the dust bin
lter.
4. Lift the dust bin lid upward while pressing the
separation button on the dust bin.
5. Empty the dust bin and clean it with a cleaning
brush or under running water.
6. After cleaning with water, completely dry the
dust bin in a well-ventilated area out of direct
sunlight.
7. Reassemble the dust bin, putting the sponge
and particulate lter back in and closing the lid.
※
Refer to p.51 for detailed assembly guides.
8. Put the dust bin into the Robot Cleaner and
close the dust bin compartment cover.
If the dust bin is full, suction power may be reduced. Clean the dust bin before or after each cleaning
session. Clean the dust bin using the following sequence:
Loading ...
Loading ...
Loading ...