Loading ...
Loading ...
Loading ...
36
Troubleshooting Chart
--------
Oven Problem Possible Causes and Suggested Solutions
Oven door is locked and will not open, even after
cooling.
Turn the oven off at the circuit breaker and wait five minutes.
Turn breaker back on. The oven should reset itself and will
be operable.
Oven is not heating. Check circuit breaker or fuse box to your house. Make sure
there is proper electrical power to the oven. Be sure oven
temperature has been selected.
After switching on an operating mode, a message is
shown on the display that indicates that the
temperature is too high.
The appliance has not cooled sufficiently. Allow the
appliance to cool and switch the operating mode on again.
Oven temperature is too hot or too cold. The oven thermostat needs adjustment. See “Oven
Temperature Offset“ under “Adjust Basic Settings“.
Oven light is not working properly. Replace or reinsert the light bulb if loose or burned out.
Touching the bulb with fingers may cause the bulb to burn
out.
Oven light does not turn off. Check for obstruction in oven door. Check to see if hinge is
bent.
Cannot remove lens cover on light. There may be soil build-up around the lens cover. Wipe lens
cover area with a clean dry towel prior to attempting to
remove the lens cover.
Oven is not self-cleaning properly. Allow the oven to cool before running self-clean. Always wipe
out loose soils or heavy spillovers before running self-clean.
If oven is badly soiled, set oven for the maximum self-clean
time.
Clock and timer are not working properly. Make sure there is electrical power to oven.
“E“ and a number appears in display and control
beeps.
This is a fault code. Follow the instructions in the display. If
the code remains or there are no instructions in the display,
press INFO to display more information (if applicable) and to
turn off the beep. If the code is still displayed, write down the
fault code number, turn off the oven, and call Service.
With a new oven there is a strong odor when oven is
turned on.
This is normal with a new oven and will disappear after a few
uses. Operating the self-clean cycle also “burns-off“ the
smell more quickly.
Control does not react when a key is touched. Be sure that pad is clean. Touch the center of the touchpad.
Use the flat part of your finger.
Fan is running during modes that do not use
convection.
On some models, the convection fan runs while the oven is
preheating for the bake mode. This is normal.
Warm air or steam escapes from oven vent. It is normal to see or feel steam or warm air escaping from
the oven vent. Do not block the vent.
Cooling fan runs even when the oven is turned off. This is normal. The cooling fan will continue to run, even after
the oven has been turned off, until the oven has cooled
sufficiently.
Oven door closes faster/slower than normal. The soft-close door hinges contain a damping fluid that is
affected by temperature. If the oven is in a cold environment,
the door will close slower than it will in a warmer
environment. A warmer than normal environment, such as
when cooking, may cause the door to close slightly faster.
The appliance cannot be switched on or is on and
cannot be operated; the ‚ symbol is shown on the
display.
The panel lock is activated. Press and hold the LOCK touch
button (or TIMERS, if LOCK is not present) until the ‚
symbol goes away.
The appliance does not heat up; 6 is shown on the
display.
Demo mode is activated in the basic settings. Turn demo
mode to OFF in the settings menu.
Loading ...
Loading ...
Loading ...