Loading ...
Loading ...
Loading ...
21
Consumer SupportInstallation Instructions Troubleshooting TipsOperating InstructionsSafety Instructions
Using the clock and timer.
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a timed baking
or self-cleaning cycle.
Press the CLOCK pad.
Depending on which model you have,
you will set the clock by pressing either
the number pads or + or – pads.
Press the number pads the same way you
read them. For example, to set 12:34, press
the number pads 1, 2, 3 and 4 in that order.
If number pads are not pressed within one
minute after you press the CLOCK pad, the
display reverts to the original setting. If this
happens, press the CLOCK pad and reenter
the time of day.
Press the START pad. This enters the
time and starts the clock.
To check the time of day when the display is
showing other information, simply press the CLOCK
pad. The time of day shows until another pad is
pressed.
Make sure the clock is set to the
correct time of day.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 11 hours
and 59 minutes.
Press the KITCHEN TIMER ON/OFF pad.
Press the + or – or number pads to
set the time. For example, to enter 2
hours and 45 minutes, touch 2, 4 and 5
in that order.
If you make a mistake, press the KITCHEN TIMER
ON/OFF pad and begin again.
Press the START pad. After pressing
the START pad, SET disappears; this
tells you the time is counting down,
although the display does not change
until one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
KITCHEN TIMER ON/OFF pad is pressed.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a Timed
Cycle. Display then shows the time of day.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
To reset the clock, press the CLOCK pad.
Enter the correct time of day by pressing
the + or – or the appropriate number pads.
Press the START pad.
GEAppliances.com
Loading ...
Loading ...
Loading ...