Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
40
6.3 To Adjust an Oven Door Angle
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 10.11). Loosen the bottom
hinge xing screws and use the notch and a at bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 10.12).
Retighten the hinge screws.
6.4 To Replace an Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the oven door slightly and remove the 4 front panel
xing screws from the door sides (2 each side), (Fig. 10.13).
Carefully lift o the outer door panel.
Remove the door handle from the panel by unscrewing the 2
retaining nuts.
Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
6.5 To Change the Oven Door Latch
Remove the outer door panel (see 6.4). Remove screws ‘B’,
which hold the latch assembly to the inner door panel (Fig.
10.14). Fit the new catch and reassemble in reverse order.
Check the door operation.
6.6 To Adjust an Oven Door Catch Keep
Open the oven door, slacken o the locknut at the base of the
keep, and screw in or out as required until the required t is
obtained. Retighten the locking nut
(Fig. 10.15).
6.7 To Change an Oven Door Seal
Open the oven door. The seal is held in place by small hooks
on the rear face. At the corner, pull the seal diagonally away
from the door centre until that hook is released (Fig. 10.16).
Proceed to the next hook and release it in a similar way, and
so on. Use force if the hooks are sti, as the old seal will be
discarded.
When tting the new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of the
door, and proceed round the door, snapping in each hook in
turn.
6.8 Oven Door Glass
The glass on the oven doors is not replaceable.
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0006 Oven door hinge adjustment 1
ArtNo.320-0007 Oven door hinge adjustment 2
Eect of hinge adjustment – exagerrated for clarity
Centreline of hinge pin
Oven door omitted for clarity
ArtNo.320-0003 Oven door latch
B
ArtNo.320-0004 Oven door keep
ArtNo.320-0005 Oven door rubber seal
Fig. 10.11
Fig. 10.12
Fig. 10.13
Fig. 10.14 Fig. 10.15
Fig. 10.16
Loading ...
Loading ...
Loading ...