Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is gas sound when you have nished.
27
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical oor mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
ArtNo.011-0007 - Restraining chain (AUS)
Restraining
chain
Fitting the Stability Bracket and
Chain
A stability bracket and chain MUST be tted when
the cooker is connected to a exible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT: The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use a
13 mm spanner or socket wrench to turn the adjusting nuts at
the front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
Fitting the Stability Bracket
When tting the stability bracket; rst attach the bracket
location device to the rear of the cooker (Fig. 8.6). Then
adjust the bracket to engage through the slot of the device
(Fig. 8.7 and Fig. 8.8).
Fitting the Restraining Chain
The restraining chain MUST be tted.
The length of chain between the appliance and the wall xing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Measure the length of chain required. Use the clamp supplied
to clamp onto the gas pipe (Fig. 8.9). Fix the supplied hook
securely to the wall.
Repositioning Following Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 8.5), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have sucient slack to allow the cooker to
move.
With a stability chain tted, release it as you ease the cooker out.
Do not forget to ret it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
Fig. 8.6
Fig. 8.7
Fig. 8.8
Fig. 8.9
Alternative positions
for stability location
bracket
Loading ...
Loading ...
Loading ...