Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
37
ArtNo.160-0008 - Bray grill burner fixing screws
A
C
D
B
A – Grill electrode plate xing screw, B – Position of grill burner
xing screws, C – Front shield xing screws, D – grill venturi
Grill
BEFORE SERVICING ANY GAS CARRYING COMPONENTS,
TURN OFF THE GAS SUPPLY.
4.1 To Change the Grill Control Tap
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Lift up the right-hand
hotplate tray front (see 2.1). Undo the gas connection to
rear of valve and remove the screw(s) securing tap to gas
rail. Remove old tap, discard the old gasket/seal. Fit the new
gasket/seal to the new tap.
Reassemble in reverse order. Check the tap is adjusted for the
correct gas. Check the appliance is gas sound.
4.2 To Change the Grill Injector
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1).
Lift up the spring clip retaining the grill injector holder and
slide the injector holder out of the burner venturi (Fig. 10.5).
Remove the grill jet from adaptor and t a new jet (see the
ratings table for correct jet). Put the injector holder back in
the burner venturi.
4.3 To Change the Grill Burner
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the grill injector (see 4.2).
Remove the 2 screws holding the front shield and remove the
shield. Turn the grill venturi clockwise to clear the front cross-
member, lift up and remove
(Fig. 10.6).
For models with ignition disconnect the electrode lead
and remove the screw holding the plate around the grill
electrode. Support the grill burner from below and remove
the 2 screws (under the foil wrap) securing grill burner to the
top of grill chamber. Remove the grill burner.
Reassemble in reverse order taking care not to damage the
grill electrode (where tted).
4.4 To Change the Grill Electrode
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the grill burner (see 4.3). Withdraw the electrode
and pull o the electrode lead. Fit the lead to the new
electrode.
Reassemble in reverse order and check ignition is satisfactory.
Spring clip
Grill injector holder
Fig. 10.5
Fig. 10.6
Loading ...
Loading ...
Loading ...