Loading ...
Loading ...
Loading ...
18
NOTE: The oven doors are triple glazed, the inner two panels
are xed together and should not be separated.
After cleaning, carefully ret the outer door panel and replace
the side xing screws.
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.
Ovens
Cleaning is easier if carried out while the oven is still warm.
Before cleaning, cover the burner to prevent the burner holes
becoming blocked.
The inside of the oven and inner door panel can be cleaned
using an approved cleaner (Table 6.1).
Take care not to disturb the oven thermostat temperature
sensor at the top of the oven opening (Fig.6.11).
The enamelled oven burner trim (Fig.6.12) can be removed
for cleaning. The oven burner trim hooks onto the front of the
oven burner bracket. When retting make sure that the trim is
in the middle of the front of the oven burner bracket (Fig.6.13).
‘Cook & Clean’ Panels
The main oven has panels which have been coated with a
special enamel that partly cleans itself. This does not stop
all marks on the lining, but helps to reduce the amount of
manual cleaning needed.
The ‘Cook & Clean’ panels work better above gas mark6
(200 °C). If you do most of your cooking below this
temperature, occasionally remove the panels and wipe with
a lint free cloth and hot soapy water. The panels should then
be dried and replaced and the oven heated at gas mark6
(200 °C) for about one hour. This will make sure that the ‘Cook
& Clean’ panels are working eectively.
DO NOT use steel wool, oven cleaning pads, or any
other materials that will scratch the surface.
Removing the Main Oven Linings
Some of the lining panels can be removed for cleaning. If you
wish to clean the enamel interior of the oven, you will need to
remove the shelves before removing the ‘Cook & Clean’ panels.
You do not have to remove the support brackets to remove the
panels. Lift each panel upward and slide forward o the support
brackets (Fig.6.11). Once the panels have been removed, the
oven enamel interior can be cleaned. Ret in the reverse order.
Thermostat temperature sensor
ArtNo.323-0009 - Bray burner shield fitted
Oven burner trim
ArtNo.323-00011 - Bray burner front shield
Fig.6.11
Fig.6.12
Fig.6.13
Fig.6.14
Loading ...
Loading ...
Loading ...