Falcon CLA110NGFCY-CH 110cm Freestanding Natural Gas Oven/Stove

User Manual - Page 35

For CLA110NGFCY-CH.

PDF File Manual, 48 pages, Download pdf file

Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is gas sound when you have nished.
31
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
ArtNo.215-0026 - Handle gaskets fixed
Art No 215-0028 - Handrail fascia fixings
Fig. 8.18
Fig. 8.19
Fig. 8.20
Final Checks
Note: The clock must be set before the ovens will work. See
The Clock’ section for instructions on setting the time of day.
Hotplate Check
Check each burner in turn. There is a Flame Supervision
Device (FSD) that stops the ow of gas to the burner if the
ame goes out. For each burner, turn the control knob to the
solid ame symbol. Press in the control knob. This lets gas
through to the burner. Keep holding the knob pressed in and
press the igniter button or light with a match. Keep holding
the control knob pressed in for about 10 seconds.
If, when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier in the instructions, and then
turn on the ovens. Check that the ovens start to heat up.
Note: The oven light bulb is not included in the guarantee.
Turn o the ovens.
Final Fitting
Fitting the Handles and Handrail
Remove the 4 mm Allen screws from the doors (Fig. 8.18). Fit
the door handles and secure using the 4 mm screws.
The handles should be above the xings.
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig. 8.19). Fit the handrail in position and secure using
the 4 mm screws.
Fitting the Plinth
Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 8.20).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth
(Fig. 8.21). Adjust the height of the outer plinth by sliding it
up or down via the slotted hole.
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth
Outer plinth xing screw
Inner plinth
Fig. 8.21
Loading ...
Loading ...
Loading ...