User Manual - Page 68

For LEON SC 2013.

Loading ...
Loading ...
Loading ...
66 Instruments and warning/control lamps
Press and hold the button ⇒ Fig. 38
4
for more than 5 seconds to consult
the service message.
When the service date has past, a minus sign is displayed in front of the
number of kilometres or days. In vehicles with text messages the following
is displayed: Service --- km (miles) or --- days ago.
The time can also be set via the

key and
Setup
function button in the
Easy Connect system ⇒ page 79.
The service interval display is reset
If the service was not carried out by a SEAT dealership, the display can be
reset as follows:
To reset the service interval display, turn the ignition off and press and
hold the button ⇒ Fig. 38
4
.
Switch the ignition back on.
Release the button
4
and press the button
4
again for the next 20
seconds.
Note
The service message disappears after a few seconds, when the engine is
started or when
OK/RESET
is pressed on the windscreen wiper lever, or
OK
on the multifunction steering wheel.
In vehicles with the LongLife system in which the battery has been dis-
connected for a long period of time, it is not possible to calculate the date
of the next service. Therefore the service interval display may not be correct.
In this case, please check the maximum permitted service intervals ⇒ Book-
let Maintenance Programme.
Rev counter
The rev counter indicates the number of engine revolutions
per minute.
Together with the gear-change indicator, the rev counter offers you the pos-
sibility of using the engine of your vehicle at a suitable speed.
The start of the red zone on the dial indicates the maximum engine speed
which may be used briefly when the engine is warm and after it has been
run in properly. Before reaching this range, you should change to a higher
gear for vehicles with a manual gearbox or for automatic gearboxes put the
selector lever in “D” or take your foot off the accelerator pedal.
We recommend that you avoid high revs and that you follow the recommen-
dations on the gear-change indicator. Consult the additional information in
⇒ page 68, Gear-change indicator.
CAUTION
Never allow the rev counter needle
1
⇒ Fig. 38 to go into the red zone on
the scale for more than a very brief period, otherwise, there is a risk of en-
gine damage.
For the sake of the environment
Changing up a gear early will help you to save fuel and minimise engine
noise.
Loading ...
Loading ...
Loading ...