Loading ...
Loading ...
Loading ...
Installation
56
• If installed in a worktop with rear wall,
ensure that the worktop is made of a
non-combustible material.
Cut an opening in the worktop of the
support structure with the dimensions
indicated in the figure (all measurements
are given in mm).
Hole for running connections
Make a circular hole of minimum 100 mm
to allow electricity and gas connections to
be run. The hole may be made on the right-
hand side or in the rear of the supporting
structure, always on the right, in
correspondence with the appliance’s gas
intake.
(all measurements are expressed in mm).
Side view
Rear view
This appliance requires a front
opening in the support structure.
During cooking, take care not to
obstruct the fat drainage hole in
the front of the appliance. If
necessary, clean it thoroughly with
the aid of a wooden or plastic
utensil.
Loading ...
Loading ...
Loading ...