Loading ...
Loading ...
Loading ...
Driving
●
Electrica
l components with a high power
consumption are switched off temporarily
when the engine starts.
●
When starting with a cold engine, noise
levels may briefly increase. This is quite nor-
mal, and no cause for concern.
●
When the outside temperature is below
+5°C (+41°F), if the engine is diesel, some
smoke may appear under the vehicle when
the fuel-operated auxiliary heater is on.
Stopping the engine
3 Valid for vehicles: with Keyless Access
Step
Switch off the engine with the starter
button ››› page 171.
1. Stop the vehicle completely ››› .
2.
Press and hold the brake pedal until the step
4 is performed.
3.
If you are driving an automatic vehicle, place
the selector lever in position P.
4.
Connect the electronic parking brake
››› page 174.
5.
Briefly press the start-up button ››› Fig. 166.
The
START ENGINE STOP
button blinks again. If
the engine fails to switch off, perform an emer-
gency disconnect ››› page 171.
6.
If the vehicle is equipped with a manual gear-
box, put it into 1st or reverse.
WARNING
Never switch off the engine while the vehicle
is mo
ving. This could cause loss of control of
the vehicle, accidents and serious injury.
●
The airbags and belt tensioners do not
work when the ignition is switched off.
●
The brake servo does not work with the en-
gine off. Therefore, you need to press the
break pedal harder to brake the vehicle.
●
Power steering does not work when the en-
gine is not running. You need more strength
to steer when the engine is switched off.
●
If the ignition is switched off, the steering
column could be locked, making it impossible
to control the vehicle.
CAUTION
If the engine is made to work hard for a long
time, it ma
y overheat after being switched
off. To prevent damage to the engine before
switching it off, leave it idle for approx. 2 mi-
nutes in neutral.
Note
After switching off the engine, the cooling fan
may
continue to operate in the engine com-
partment for a few more minutes, even with
the ignition off. The radiator fan is automati-
cally switched off.
“My Beat” Function
For vehicles with a convenience key there is
the “My B
eat” function. This feature provides
an additional indication of the vehicle igni-
tion system.
When accessing the vehicle, e.g. by opening
the doors with the remote control, the
START ENGINE STOP
button flashes, drawing at-
tention to the r
elevant starter system button.
Upon switching the ignition on/off, the light
of the
START ENGINE STOP
button flashes. With
the en
gine sw
it
ched off, after a few seconds,
the
STOP ENGINE START
button stops flashing
and g
oe
s
out.
With the engine running, the
START ENGINE STOP
button light stays on, indi-
c
atin
g th
at the engine is running. Upon
switching the ignition off with the
START ENGINE STOP
button, it starts flashing
ag
ain.
In
v
ehicles with the Start-Stop system, the
“My Beat” function also offers additional in-
formation:
●
When the engine stops during the Stop
phase, the light of the
START ENGINE STOP
but-
t
on s
t
ays on, since, even though the engine
is off, the Start-Stop system is active.
●
When the engine cannot be stated again
with the Start-Stop system,
›››
page 192, and
needs to be started manually, the
»
173
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...