Loading ...
Loading ...
Loading ...
Metal crossbars are offered by Mopar accessories to pro-
vide a functional roof rack system. See an authorized
dealer.
To Move The Crossbars
1. Loosen the knobs on top of each crossbar approximately
six turns to disengage the clamp tooth from the side rail.
2. Relocate the crossbars, aligning the crossbar stanchions
(end pieces) with one of the vertical marks on the
outboard surface of the side rail for proper positioning.
There are four frontward marks for the front crossbar
and four rearward marks for the rear crossbar. Make
sure the crossbars remain equally spaced or parallel at
any position for proper function.
3. Tighten the knobs on each crossbar to lock it in position.
As you tighten the knob, make sure the clamp tooth
engages completely into the side rail slot.
4. Attempt to move the crossbar to ensure that it is locked
in position.
NOTE:
• To help control wind noise when installing the crossbars,
make sure the arrows marked on the underside of the
crossbars face the front of the vehicle.
• To help reduce the amount of wind noise when the
crossbars are not in use, fasten the front crossbar in the
fourth position from the front and the rear crossbar in
the eighth position. The tie down holes on the crossbar
ends should always be used to tie down the load. Check
the straps frequently to be sure that the load remains
securely attached.
Crossbar Knobs
132 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...