Loading ...
Loading ...
Loading ...
18
|
INSTALLATION / USE & CARE
GA
S
CO
NNE
C
TI
O
N
S
...
co
n
t
in
u
e
d
Insert the regulator inlet into the cylinder valve and turn the
black coupler clockwise until the coupler is hand tight. Do not
over-tighten this connection.
To disconnect the coupler, rst make sure the main cylinder
valve is turned o . Grasp the coupler and turn counter
clockwise. The inlet will then disengage.
Always leak-test the connection after re lling or exchanging LP
cylinders. (See INDEX: “Leak Test” for further details.)
GAS LINE PURGING
You should purge the gas line of air before attempting to light
the grill.
• Make sure all grill controls are in the “OFF” position.
• Slowly turn on the main gas supply.
• Push in the rotisserie knob and con rm that the igniter is
glowing. It is furthest from the fuel source and will completely
purge the lines. It will take several seconds for the burner to
light.
• Hold the knob ON for about 20 seconds to allow the air in the
system to purge and the burner to light
• Wait at least 5 minutes after shutting o the control before
attempting to light the burners.
GAS CONVERSION KITS
Gas conversion kits are available from Viking Range, LLC to
allow the grill to operate on either Natural gas or LPG. These kits
should be installed by a quali ed technician.
The kits come with complete installation instructions. These
instructions should be read completely and fully understood
before installing the conversion kit.
BUILTIN SIDE BURNER INSTALLATION
• Shut o the gas supply at the main valve.
• Disconnect all plumbing (if already attached) from the grill and
the gas supply valve.
• Remove all the ttings from the grill manifold.
• Install the side burner into the counter top cutout.
• Connect the gas supply to the grill and side burner as shown in
the two diagrams on this page.
• Turn the gas supply on and leak test all connections. (See
INDEX: “Leak Test” for further details.)
CART INSTALLATION
• Shut o the gas supply at the main valve.
• Disconnect all plumbing (if already attached) from the grill and
the gas supply valve.
• Remove all the ttings from the grill manifold.
• Install the side burner onto the cart according to the directions
supplied with the cart mounting kit.
• Connect the gas supply to the grill and the side burner as
shown in the diagrams on this page for your gas type.
• Turn the gas supply on and leak test all connections. (See
INDEX: “Leak Test” for further details.)
Loading ...
Loading ...
Loading ...