Loading ...
Loading ...
Loading ...
17
LEVELING THE DRYER
To ensure that the dryer provides optimal drying
performance, it must be level. To minimize vibration,
noise, and unwanted movement, the fl oor must be a level,
solid surface.
NOTE: Adjust the leveling feet only as far as necessary
to level the dryer. Extending the leveling feet more than
necessary can cause the dryer to vibrate.
WARNING:
• To reduce the risk of injury to persons, adhere
to all industry recommended safety procedures
including the use of long sleeved gloves and
safety glasses. Failure to follow this warning can
cause serious injury or death.
• The appliances are heavy. Two or more people
are required when installing the dryer. Failure to
follow this warning can cause serious injury or
death.
1
Position the dryer in the fi nal location. Place a level
across the top of the dryer.
Level
Levelin
g
Feet
All four leveling feet must rest solidly on the fl oor.
Gently push on the top corners of the dryer to make
sure that the dryer does not rock from corner to corner.
2
Use a wrench to turn the leveling feet. Turn the leveling
foot clockwise to raise the dryer or counterclockwise
to lower the dryer. Using a level, adjust the feet until
the dryer is level from side to side and front to back.
Make sure all four feet are in fi rm contact with the
fl oor.
NOTE: If you are installing the dryer on the optional
pedestal, the dryer leveling feet should be fully retracted.
Use the leveling feet on the pedestal to level the dryer.
REVERSING THE DOOR SWING
WARNING:
THE DRYER DOOR IS VERY LARGE AND HEAVY.
Failure to follow the instructions below can result
in damage to the dryer, property damage or
personal injury.
• To avoid damage to the dryer or the door, support
the door with a stool or box that fits under the
door, or have an assistant support the weight of
the door.
• Avoid dropping the door to avoid damage to the
door or the floor.
• Unplug the dryer or turn off power at the main
circuit breaker before beginning door reversal.
Tools Required
Phillips or large flat-blade screwdriver (for hinge
screws)
Small flat blade screwdriver
(for lifting out parts)
Door Reversal Instructions
NOTE: The instructions here are for changing the door
swing from a right to a left side hinge. If the door has
been reversed, and it is necessary to change it back,
use care when following these instructions. Some of the
illustrations and the left/right references will be reversed,
and you will need to read the instructions carefully.
Swing Door
1
Open the door from the side so that the hinge screws
are accessible.
WARNING:
Be sure to support the weight of the door before
removing the hinge screws.
2
Remove the 4 hinge screws.
While supporting the door, remove the 4 hinge screws,
2 from each hinge. Set the door aside face down on a
protected surface to prevent damage to the door or
the work surface.
Two large
screws
Two small
screws
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...