Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
52
The length of the
programme changes
during the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
There is water remaining
in the care product
compartment i .
■ Not a fault – the effectiveness of the care product is not affected.
■ Clean the insert if necessary.
Odours in the washing
machine.
Run the Drum Clean 90 °C or Cottons 90 °C programme without laundry.
Add standard washing powder or a detergent that contains bleach.
Note: . To prevent foaming, only use half the amount of detergent
recommended by the detergent manufacturer. Do not use detergent designed
for woollens or delicates.
The o symbol is lit on the
display panel. Foam may
also be leaking from the
detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment II (not suitable for outdoor clothing, sportswear or items filled
with down).
Use less detergent in the next wash cycle.
Loud noises, vibrations
and machine "wandering"
during the spin and/or
drain cycles.
■ Is the appliance level? Level the appliance. ~ Page 20
■ Are the appliance's feet secured? Secure appliance's feet. ~ Page 20
■ Have the transport locks been removed? Remove the transport locks.
~ Page 17
The display panel/
indicator lights do not
work while the appliance
is running.
■ Has there been a power failure?
■ Have the fuses blown/has the circuit breaker tripped? Switch on the circuit
breaker/replace the fuses.
■ If the fault occurs repeatedly, call our after-sales service.
There is detergent
residue on the laundry.
■ Some phosphate-free detergents contain water-insoluble residue.
■ Select Rinse or brush the laundry after washing.
The Πsymbol is lit in the
display panel when
paused.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
■ Press the I button to continue the programme.
The Πsymbol in the
display panel is off when
paused.
The door is unlocked. It is possible to add laundry.
timeLight (display on the
floor) will not light up.
■ Has Timelight been activated? ~ Page 43
■ Energy saving mode is active. ~ Page 13
■ Has there been a power failure?
If you cannot rectify a fault yourself (after switching the machine off and then on again) or a repair is
required:
■ Switch off the appliance and pull the mains plug out of the socket.
■ Turn off the tap and our after-sales service.
Faults Cause/remedy
Loading ...
Loading ...
Loading ...