Loading ...
Loading ...
Loading ...
Positioning and connecting en
27
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any water that may be left over
from testing, run the first wash cycle
without any laundry.
Note: The washing machine must be
correctly installed and connected. See
~ Page 14 onwards
Preparatory work:
1. Plug the mains plug into the mains.
2. Turn on the tap.
Run a programme without laundry:
1. Switch on the appliance.
2. Close the door (do not load any
laundry).
3. Set the 90 °C Drum Clean
programme.
4. Open the detergent drawer.
5. Pour approximately 1 litre of water
into compartment II.
6. Pour standard washing powder into
compartment II.
Note: To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergent
designed for woollens or delicates.
7. Close the detergent drawer.
8. Press the I button.
9. Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.
Loading ...
Loading ...
Loading ...