Loading ...
Loading ...
Loading ...
Faults and what to do about them. en
51
Faults and what to do about them.
Symbol in timeLight
(display on the floor):
Cause/remedy
:
|
ä
■ A fault has occurred ~ See "E" above: ...
■ See symbol above
■ See symbol above
Faults Cause/remedy
Water is leaking from the
machine.
■ Attach the drain hose correctly or replace it.
■ Tighten the threaded joint on the supply hose.
The machine is not filling
with water.
Detergent is not being
dispensed.
■ Have you pressed the I button?
■ Is the tap turned on?
■ Could the filter be clogged? Clean the filter. ~ Page 47
■ Is the supply hose kinked or trapped?
The door will not open. ■ The safety function is activated. Do you want to stop the programme?
~ Page 41
■ Is the childproof lock w activated? Deactivate it. ~ Page 40
■ Is "- - -" selected (Rinse Stop = no final spin)? ~ Page 41
■ Can the door only be opened using the emergency release? ~ Page 49
The programme will not
start.
■ Have you pressed the I button?
■ Is Ready in selected?
■ Is the door closed?
■ Is the childproof lock w activated? Deactivate it. ~ Page 40
The drum briefly jerks or
judders after the
programme has started.
Not a fault – the internal motor test may cause the drum to jerk or judder briefly
when the wash programme starts.
The water is not draining. ■ Is "- - -" selected (Rinse Stop = no final spin)? ~ Page 41
■ Clean the drain pump. ~ Page 46
■ Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not
satisfactory.
Laundry is wet/too damp.
■ Not a fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum.
■ Is Anti-crease (depending on the model) selected? ~ Page 36
■ Is the selected speed too low?
The spin cycle runs
several times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■ Not a fault – the unbalanced load detection system is adjusting an
imbalance by repeatedly redistributing the laundry.
■ Not a fault – the foam detection system has activated an additional a rinse
cycle.
Loading ...
Loading ...
Loading ...