Loading ...
Loading ...
Loading ...
32 Changing The Filter
More about your advanced water
filter
6 Press a drinking glass against the water
dispenser while checking for any leaks
at the filter housing. Any spurts and
sputters that occur as the system purges
air out of the dispenser system are
normal.
7 After filling one glass of water, continue
flushing the system for about three
minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button
on the Ice & Water Dispenser control
panel for three seconds. When the
display changes from “Replace” to
“Good,” the status has been reset.
Do not use with water that is microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Systems certified for cyst reduction
may be used on disinfected waters that may
contain filterable cysts.
Test & certification results:
• Rated Capacity - 400 gallons for
PureAdvantage
TM
ice and water filter
• Rated service flow - .5 gallons per
minute
• Maximum Rated Pressure - 100 pounds
per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureAdvantage
TM
water
filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker power switch.
2 Push the filter release button below the
cartridge to disconnect it.
3 Slide the old water filter cartridge straight
out of the housing and discard it.
4 Unpackage the new filter cartridge and
slide it gently into the filter housing until
it stops against the snap-in connector at
the back of the housing.
5 Push firmly until the cartridge snaps
into place (you should hear a click
as the cartridge engages the snap-in
connector). When fully engaged, the
front of the filter cartridge should be flush
with the filter release button.
The PureAdvantage
TM
ice
and water filter system is
tested and certified by NSF
International to NSF/ANSI
Standards 42 and 53 for the
reduction of claims specified
on the performance data
sheet.
Loading ...
Loading ...
Loading ...