1. Home
  2. Schwinn
  3. Schwinn 510T User Manual
  4. Page 40

ASSEMBLY MANUAL - Page 40

For 510T. Also, The document are for others Schwinn models: 810

Loading ...
Loading ...
Loading ...
40
To reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before
cleaning, maintaining or repairing this machine. Place the power cord in a secure location.
Note: Make sure the treadmill is located on a surface that is easy to clean.
3. Apply a few drops of the lubricant on the deck below the belt. Carefully lift the belt and apply a few drops of the lubri-
cant the entire width of the belt. A very thin layer of silicone lubricant on the entire deck below the belt is desired.
NOTICE: Always use a 100% pure silicone lubricant. Do not use a degreaser like WD-40
®
as this could seriously im-
pact performance. We can recommend that you use the following:
• 100% pure silicone, available at most hardware and auto parts stores.
• Lube-N-Walk
®
TreadmillLubricationKit,availablefromyourlocalspecialtytnessdealerorNautilus,Inc.
Silicone lubricant is not intended for human consumption. Keep out of reach of children. Store in a safe
place.
4. Manually rotate the belt 1/2 of the length of the belt and apply lubricant again.
If you used spray lubricant, wait 5 minutes before turning on power to the machine to allow the aerosol to
dissipate.
5. Connect the power cord back into the machine and then into the wall outlet.
6. Turn on the power to the machine with the power switch.
7. Staytoonesideofyourmachineandstartthebeltattheslowestspeed.Letthebeltoperateforapproximately15
seconds.
Be sure not to touch the walking belt or step on the power cord. Keep bystanders and children away from
the product you are servicing at all times.
8. Switcho󰀨yourmachine.
9. Takecaretocleanupanyexcesslubricantfromthedeck.
To decrease the possibility of slipping, be sure the deck area is free from grease or oil. Clean o󰀨 any excess
oil from the machine surfaces.
Asyouuseyourtnessmachine,theConsolewillshow“LUBRICATEBELT”followedby“REVIEWUSERMANUAL”at
set times. This is only a reminder and should be added to your inspection schedule. Only apply lubricant as necessary.
Push any button to accept the reminder.
Loading ...
Loading ...
Loading ...