510T ASSEMBLY MANUAL

Loading ...

• Always attach the Safety Key Clip to your clothing during workouts.

 •Ifthereisanemergency,pullouttheSafetyKeytoshuto󰀨thepowertotheBeltandInclineMotors.Thiswillquickly

stop the belt (brace yourself- this is an abrupt stop) and clear the workout. Push the PAUSE/STOP button to stop the

belt and pause the program.

7. Push the USER button to select the desired User for the workout.

8. Push the Workout Category button until your workout is displayed.

9. PushtheOKbuttontoselecttheworkout.

10. TheConsolewillaskaseriesofquestionstocustomizetheworkout.UsetheIncrease() or Decrease() buttons to

adjust the workout values, and push the OK button to accept each of them.

11. With your desired workout shown on the Console, push the START button.

12. When the Console displays the “READY ?” prompt, push the START button. The Console will display “RAMPING UP”

as the Walking Belt gets up to speed. Be sure to carefully step onto the walking belt.

The belt will only move after a 3 second, audible beep countdown.

Always use the handlebars to step on or o󰀨 the treadmill, or when the incline or speed change.

To perform an emergency dismount, grab onto the Front or Side Handlebars and safely step onto the Side

Foot Platforms. Bring the Walking Belt to a stop and carefully step o󰀨 the machine.

Note: Yourtreadmillcomesequippedwithadurable,highqualitywalkingbeltdesignedtoprovidemanyhoursof

reliable service. The walking belt on a treadmill that has not been operated for a length of time, either in factory

packagingorafterassembly,canexhibita“thumping”noisewhenstarted.Thisisduetothebelttakingonthecurve

of the front and rear rollers. This is a common occurrence and does not indicate a problem with your machine. After

the treadmill has been used for a short period of time the thumping noise will discontinue. The amount of time will vary

depending on the temperature and humidity of the environment where the treadmill is placed.

Power-Up / Idle Mode

The Console will enter Power-Up / Idle Mode if it is plugged into a power source, the Power Switch turned on, and the

Safety Key is properly installed.

Note: IftheSafetyKeyisnotinstalled,themachinewillallowtheUsertoperformallactivitiesexcepttoactivatethe

Walking Belt. The Console will display the reminder to insert the Safety Key ( “SAFETY KEY” ). Once the Safety key

is installed, the START button will need to be pushed again to begin the selected Workout.

Auto Shut-O󰀨 (Sleep Mode)

IftheConsoledoesnotreceiveanyinputinapproximately5minutes,itwillautomaticallyshuto󰀨.TheLCDdisplayiso󰀨

while in Sleep Mode.

To disconnect, turn all controls to the o󰀨 position, then remove plug from outlet.

Quick Start ( Manual ) Program

The Quick Start ( Manual ) program lets you start a workout without entering any information.

During a Manual Workout, each column represents a 1 minute and 52 seconds time period. The active column will

advance across the screen every 1 minute and 52 seconds. If the workout lasts for more than 30 minutes, the active

columnisxedonthefarthestcolumnontherightandpushesthepreviouscolumnso󰀨thedisplay.

1. Stand on the Side Foot Support Platforms.

Loading ...

ASSEMBLY MANUAL - Page 31