Loading ...
Loading ...
Loading ...
31
Changing the Filter(s)
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Systems
certified for cyst reduction may be used
on disinfected waters that may contain
filterable cysts.
Test & certification results:
• Rated Capacity - 125 gallons/473
liters for PureAdvantage Ultra ice and
water filter
• Rated service flow - .65 gallons per
minute
• Operating Temp: Min. 33°F, Max.
100°F
• Maximum Rated Pressure -
100pounds per square inch
• Recommended Minimum Operating
Pressure: 30pounds per square inch
Replacing your PureAdvantage
Ultra Water Filter:
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe
up any small amounts of water released
during the filter replacement.
1 Turn Off the ice maker power switch.
2 Remove the old filter by rotating it
counter-clockwise (to the left) 90
degrees to release it.
3 Slide the old filter cartridge straight
out of the housing and discard it.
4 Unpackage the new filter cartridge.
Slide it into the filter housing as far as
it will go with the grip end vertical.
5 Push lightly inward on the filter while
rotating it clockwise (to the right). The
filter will then pull itself inward as it is
rotated. Rotate the filter 90 degrees
until it stops and the grip end is
horizontal. You may be able to feel a
very light click as the filter locks into
place.
The PureAdvantage Ultra
TM
ice and water filter system is
tested and certified to NSF/ANSI
Standards 43, 53 and 401 for
the reduction of claims specified
on the performance data sheet.
More about your Advanced Water
Filter
6 Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
7 Continue dispensing water for 3-4
minutes or until 1.5 gallons of water
has flowed through the system. You
will likely need to empty and refill your
glass several times.
8 Turn On the ice maker.
9 Press and hold the Water Filter reset
button on the control panel for three
seconds. When the display changes
from Red to Green, the status has
been reset.
Loading ...
Loading ...
Loading ...