Loading ...
Loading ...
Loading ...
19
CAUTION
For proper dispenser operation,
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause water
filter to malfunction.
NOTE
The water dispenser has a built-in
device that shuts off the water flow after
two minutes of continuous use. To reset
this shutoff device, simply release the
dispenser paddle.
Automatic Ice and Water Dispenser
Priming the water supply system
Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can start producing ice within 24
hours. The ice maker will fill the ice bin
from the rear. You must dispense some ice
to force the ice forward in the bin. Full bin
should be expected after 48 to 60 hours
with no ice usage. Ice rate is 2.0 to 2.5
pounds per day. The ice bin will hold about
4 pounds of ice.
Turning the fresh food ice maker
on and off
Turn the icemaker On and Off with the ice
maker’s On/Off icon on the control panel.
Press and hold the ice maker button on
the side display for three seconds to turn
the ice maker ON or OFF. The ice maker is
ON when the LED indicator is illuminated.
1 Begin filling the filter by pressing and
holding a drinking glass against the
water dispenser paddle.
2 Keep the glass in this position until
water comes out of the dispenser. It
may take about 1½ minutes.
3 Continue dispensing water for about
three minutes to flush the system
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).
IMPORTANT
Your ice maker is turned on at the
factory so it can work as soon as you
install your refrigerator. If you cannot
connect a water supply, set the ice
maker’s On/Off icon to Off and turn off
the water supply valve; otherwise, the
ice maker’s fill valve may make a loud
chattering noise when it attempts to
operate without water.
Fresh Food Ice Maker
Using the ice maker after
installation
Before making ice for the first time, be
sure to prime the water supply system.
Air in new plumbing lines can result in
two or three empty ice maker cycles.
Furthermore, if the system is not flushed,
the first ice cubes may be discolored or
have an odd flavor.
NOTE
After the initial 26 ounces (750 ml),
water will remain room temperature until
the tank has refilled and been given
enough time to chill the next 26 ounces
(750 ml) of water. May take up to 8
hours to chill.
Loading ...
Loading ...
Loading ...