Loading ...
Loading ...
Loading ...
20
A
Preparation for installation
The following accessories are supplied with the indoor unit.
The type and quantity may dier depending on the specications.
Accessories
Wired remote control accessories
Wired remote
control(1)
Cable-tie(2) Cable clamp(3) M4x16
tapped screw(5)
User’s
manual(1)
Installation
manual(1)
U Terminal (6)
User’s&
Installation
manual
Flexible hose Insulation drain Thermal insulation
sponge A
Thermal insulation
sponge B
Thermal insulation
sponge C
Clamp hose Rubber Cable-tie
When deciding on the location of the air conditioner with the owner, the following restrictions must be taken into account.
Do NOT install the air conditioner in a location where it will come into contact with the following elements :
◆
Combustible gases
◆
Saline air
◆
Machine oil
◆
Sulphide gas
◆
Special environmental conditions
If you must install the unit in such conditions, rst consult your dealer.
Avoid installing the air conditioner :
◆
In areas where it is exposed to direct sunlight. Close to heat sources.
◆
In damp areas or locations where it could come into contact with water. (for example rooms used for laundry)
◆
In areas where curtains and furniture could aect the supply and discharge of air.
◆
Without leaving the required minimum space around the unit. (as shown in the drawing)
◆
In scarcely ventilated areas.
◆
On surfaces that are unable to support the weight of the unit without deforming, breaking or causing vibrations
during the use of the air conditioner.
◆
In a position that does not enable the condensate drainage pipe to be correctly installed. (at the end of the
installation. It is always essential to check the eciency of the drainage system)
General
NSHHXEG model only
Loading ...
Loading ...
Loading ...