Loading ...
Loading ...
Loading ...
32
7. TROUBLESHOOTING
Manually Resetting Network IP Mode to DHCP
If errors occur when adjusting static IP settings, the MDA can
be manually set back to DHCP. Using a pin or straightened
paperclip, depress the DHCP Reset / Factory Image button for
about 1 second. The blue ID LED turns on to indicate the se-
lection of DHCP. It should take a few seconds for the server to
reassign an address.
Manually Loading the Factory Image
This function restores the MDA to its original factory image.
Any rmware updates you have done are lost and replaced by
the version programmed at the factory. The current settings,
the saved user settings, and the saved installer settings are
deleted and replaced by the factory default. ARC corrections
are also erased from local memory.
To reload the original factory image and remove all settings, set
the Master Power switch to O and wait until the lights above
the Network connection stop ashing (this may take over a
minute if the unit was in standby). Using a pin or straightened
paper clip depress and hold the DHCP Reset / Factory Image
button while turning On the Master Power switch. Continue
to depress the button until the blue ID LED ashes twice. The
Factory Image reloads (this takes about a minute). Front panel
indicators turn blue and red using a chasing pattern while the
reload is taking place.
Loading ...
Loading ...
Loading ...